A.A cut-off lever
B.A swivel block
C.A cross-head
D.A driving gear
您可能感兴趣的试卷
你可能感兴趣的试题
A.the piston rod
B.the tiller arm
C.the connecting rod
D.the rudder
A.fouled tubes in shell and tube condenser
B.too little or too warm condenser water
C.air or non-condensable gas in system
D.overcharge of refrigerant
A.The winch motor
B.The band brake
C.The winch barrel
D.The anchor capstan
A.The cable lifter
B.The hoisting motor
C.The topping wire
D.The life-raft
A.stays
B.winches
C.barrels
D.brakes
A.fire-tubes
B.furnaces
C.water drums
D.water wall tubes
A.The three moving vanes and the three fixed vanes form three pressure chambers
B.The three moving vanes and the three fixed vanes form six pressure chambers
C.The three moving vanes and the three fixed vanes form nine pressure chambers
D.The three moving vanes and the three fixed vanes form twelve pressure chambers
A.It is required that all ships are provided with two independent steering gear systems that is one main and one auxiliary
B.The auxiliary gear could be power operated in passenger ships
C.The auxiliary gear must be of adequate strength and sufficient to steer a ship at navigable speed
D.All moving parts of the steering gear must be guarded against any possible damage
A.Only one pump should be used at any time
B.The ship speed should be reduced to 70% of the normal
C.Watch keeping of the steering gear should be increased
D.Limitations of the steering gear should be logged but the bridge need not be informed
A.Surrounding the fixed shaft is a hollow shaft
B.This hollow shaft carries radial bores
C.Each bore is fitted with a well-lapped plunger
D.There are always even numbers of bores
最新试题
When the steering gear is in operation, you should （）.
Which of the problems listed would came the discharge temperature of an R-12 refrigeration compressor to increase?（）
If the thermal bulb of an expansion valve is incorrectly placed at the center of the coil instead of the end, it will （）.
Low compressor head pressure in a refrigeration system can be caused by（）.
If you are given the job of adding hydraulic fluid to a mooring winch, and are not certain as to the type of fluid to use, you should （）.
A pressure drop through the refrigerant liquid line may cause （）.
If the viscosity of the liquid being transferred remains constant as the discharge pressure increases, the rotary pump （）.
A grease gun is generally used to lubricate a （）.
The general purpose of a heat exchanger is to （）.
One cause of high head pressure occurring in a refrigeration system can be （）.