A.It divides the network communication process into smaller and simpler components, thus aiding component development, design, and troubleshooting.
B.It enables equipment from different vendors to use the same electronic components, thus saving research and development funds.
C.It supports the evolution of multiple competing standards, and thus provides business opportunities for equipment manufacturers.
D.It encourages industry standardization by defining what functions occur at each layer of the model.
E.It provides a means by which changes in functionality in one layer require changes in other layers.
您可能感兴趣的试卷
你可能感兴趣的试题
A.FTP
B.Telnet
C.SMTP
D.DNS
E.HTTP
F.POP3
A.console password
B.vty password
C.aux password
D.tty password
E.enable secret password
F.username password
A.It provides dynamic neighbor discovery.
B.It detects unreachable neighbors in 90 second intervals.
C.It maintains neighbor relationships.
D.It negotiates correctness parameters between neighboring interfaces.
E.It uses timers to elect the router with the fastest links as the designated router.
F.It broadcasts hello packets throughout the internetwork to discover all routers that are running OSPF
A.Configure port Fa0/1 to accept connections only from the static IP address of the server.
B.Employ a proprietary connector type on Fa0/1 that is incompatible with other host connectors.
C.Configure the MAC address of the server as a static entry associated with port Fa0/1.
D.Bind the IP address of the server to its MAC address on the switch to prevent other hosts from spoofing the server IP address.
E.Configure port security on Fa0/1 to reject traffic with a source MAC address other than that of the server.
F.Configure an access list on the switch to deny server traffic from entering any port other than Fa0/1.
A.application layer
B.session layer
C.transport layer
D.network layer
E.datalink layer
F.physical layer
A.RIP version 1 broadcasts updates whereas RIP version 2 uses multicasts.
B.RIP version 1 multicasts updates while RIP version 2 uses broadcasts.
C.Both RIP version 1 and RIP version 2 are classless routing protocols.
D.RIP Version 2 is a classless routing protocol whereas RIP version 1 is a classful routing protocol.
E.Both RIP version 1 and version 2 support authentication.
F.RIP version 2 sends the subnet mask in updates and RIP version 1 does not.
A.no VLANs
B.all VLANs
C.only VLANs 1 - 64
D.only the VLANs that are specified when creating the trunk
A.It creates a VLAN 999 interface.
B.It designates VLAN 999 for untagged traffic.
C.It blocks VLAN 999 traffic from passing on the trunk.
D.It designates VLAN 999 as the default for all unknown tagged traffic.
A.It checks the configuration register.
B.It attempts to boot from a TFTP server.
C.It loads the first image file in flash memory.
D.It inspects the configuration file in NVRAM for boot instructions.
A.packet switching
B.access layer security
C.path selection
D.VLAN membership assignment
E.bridging between LAN segments
F.microsegmentation of broadcast domains
最新试题
Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?()
If all OSPF routers in a single area are configured with the same priority value,what value dose a router use for the ODPF router ID in the absence of a loopback interface?()
What is the purpose of the cisco Vlan Trunking protocol?()
When you are troubleshooting an ACL issue on a router,which command can help you to verify which interfaces are affected by the ACL?()
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?()
Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?()
A router receives information about network 192.168.10.0/24 from multiple sources.What will the router consider the most reliable information about the path to that network?()
Which command encrypts all plaintext passwords?()
Which Cisco IOS diagnostics command can disrupt the operation of a router under high-load conditions?()
Which cisco ios command can help to determine the timing of various debug events,relative to each other,when you are debugging a complicated router issue?()