多项选择题Which two privileged mode cisco ios commands can be used to determine a cisco router chassis serial number?()

A.show inventory
B.show flash:filesys
C.dirflash:include chassis
D.show diag
E.show controllers


您可能感兴趣的试卷

你可能感兴趣的试题

1.多项选择题Which two statements are characteristics of a distance vector routing protocol?()

A. RIP is an example of distance vector routing protocols.
B. Updates are periodic and include the entire routing table.
C. Routing updates are sent only after topology changes
D. The protocol can be useful in hub-and-spoke and hierarchical networks.
E. Convergence is usually faster than with link state protocols
F. Each router has its own view of the topology

2.多项选择题The network technician is planning to use the 255.255.255.224 subent mask on the network.which three valid IP addresses can the technician use for the hosts?()

A.172.22.243.127
B.172.22.243.191
C.172.22.243.190
D.10.16.33.98
E.10.17.64.34
F.192.168.1.160

3.多项选择题A network administrator needs to configure port security on a switch.which two statements are true?()

A. The network administrator can apply port security to dynamic access ports
B. The network administrator can configure static secure or sticky secure mac addresses in the voice vlan.
C. The sticky learning feature allows the addition of dynamically learned addresses to the running configuration.
D. The network administrator can apply port security to EtherChannels.
E. When dynamic mac address learning is enabled on an interface,the switch can learn new addresses,up to the maximum defined.

4.多项选择题Which two statements apply to dynamic access lists?()

A. they offer simpler management in large internetworks.
B. you can control logging messages.
C. they allow packets to be filtered based on upper-layer session information.
D. you can set a time-based security policy.
E. they provide a level of security against spoofing.
F. they are used to authenticate individual users.

5.多项选择题Which two of these are characteristics of the 802.1Q protocol?()

A. it is a layer 2 messaging protocol which maintains vlan configurations across network.
B. it includes an 8-bit field which specifies the priority of a frame.
C. it is used exclusively for tagging vlan frames and dose not address network reconvergence following switched network topology changes.
D. it modifies the 802.3 frame header,and thus requires that the FCS be recomputed.
E. it is a trunking protocol capable of carring untagged frames.

6.多项选择题Which two data link layers are supported by cisco ios software for IPv6?()

A.PPP
B.FDDI
C.Frame Relay PVC
D.NBMA
E.Frame Relay SVC

7.多项选择题Which three statements accurately describe layer 2 Ethernet switches?()

A. Microsegmentation decreases the number of collisions on the network.
B. if a switch receives a frame for an unkown destination,it uses ARP to resolve the address.
C. Spanning Tree Protocol allows switches to automatically share vlan information.
D. In a properly functioning network with redundant switched paths,each switched aegment will contain one root bridge with all its ports in the forwarding state.All other switches in that broadcast domain will have only one root port.
E. Establishing vlans increases the number of broadcast domains.
F. Switches that are configured with vlans make forwarding decisions based on both layer 2 and layer 3 address information.

8.多项选择题Which two commands can be used to verify a trunk link configurationt status on a given cisco switch?()

A. show interfaces interface
B. show interfaces interface trunk
C. show interfaces interface switchport
D. show ip interface brief
E. show interfaces vlan

9.多项选择题Which commands are required to properly configure a router to properly configure a router to run OSPF and to add network 192.168.16.0/24 to OSPF area 0?()

A. Router(config)#router ospf 1
B. Router(config)#router ospf 0
C. Router(config)#router ospf area 0
D. Router(config-router)#network 192.168.16.0 0.0.0.255 area 0
E. Router(config-router)#network 192.168.16.0 0.0.0.255 0
F. Router(config-router)#network 192.168.16.0 255.255.255.0 area 0

10.多项选择题Which two statements describe the advantages to the use of RIP over the use of OSPF?()

A. RIP requires less time to converge
B. RIP uses less bandwidth
C. RIP is less complex to configure
D. RIP demands fewer router resources
E. RIP has a more accurate metric

最新试题

Which cisco ios command can help to determine the timing of various debug events,relative to each other,when you are debugging a complicated router issue?()

题型:单项选择题

While troubleshooting a network problem,a technician discovers that the current copy of the Cisco IOS is outdated and needs to be updated.Which of the following commands would the technician issue to replace the Cisco router IOS with the newer version?()

题型:单项选择题

Which command encrypts all plaintext passwords?()

题型:单项选择题

Three switches are connected to one anther via trunk ports.Assuming the default switch configuration,which switch is elected as the root bridge for the spanning-tree instance of vlan 1?()

题型:单项选择题

What is the result of issuing the frame-relay map ip 192.168.1.2 202 broadcast command?()

题型:单项选择题

Which IPsec security protocol should be used when confidentiality is required?()

题型:单项选择题

A network administrator is planning a network installation for a large organization.The design requires 100 separate subnetworks,so the company has acquired a Class B network address.What subnet mask will provide the 100 subnetworks required, if 500 usable host addresses are required per subnet?()

题型:单项选择题

The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?()

题型:单项选择题

After the show ip route command has been entered,the follwing routes are displayed.Which route will not be entered into the routing table of a neighboring router?()

题型:单项选择题

An administrator must assign static IP addresses to the servers in a network.For network 192.168.20.24/29, the router is assigned the first usable host address while the sales server is given the last usable host address. Which of the following should be entered into the IP propertied box for the sales server?()

题型:单项选择题