A.172.22.243.127
B.172.22.243.191
C.172.22.243.190
D.10.16.33.98
E.10.17.64.34
F.192.168.1.160
您可能感兴趣的试卷
你可能感兴趣的试题
A. The network administrator can apply port security to dynamic access ports
B. The network administrator can configure static secure or sticky secure mac addresses in the voice vlan.
C. The sticky learning feature allows the addition of dynamically learned addresses to the running configuration.
D. The network administrator can apply port security to EtherChannels.
E. When dynamic mac address learning is enabled on an interface,the switch can learn new addresses,up to the maximum defined.
A. they offer simpler management in large internetworks.
B. you can control logging messages.
C. they allow packets to be filtered based on upper-layer session information.
D. you can set a time-based security policy.
E. they provide a level of security against spoofing.
F. they are used to authenticate individual users.
A. it is a layer 2 messaging protocol which maintains vlan configurations across network.
B. it includes an 8-bit field which specifies the priority of a frame.
C. it is used exclusively for tagging vlan frames and dose not address network reconvergence following switched network topology changes.
D. it modifies the 802.3 frame header,and thus requires that the FCS be recomputed.
E. it is a trunking protocol capable of carring untagged frames.
A.PPP
B.FDDI
C.Frame Relay PVC
D.NBMA
E.Frame Relay SVC
A. Microsegmentation decreases the number of collisions on the network.
B. if a switch receives a frame for an unkown destination,it uses ARP to resolve the address.
C. Spanning Tree Protocol allows switches to automatically share vlan information.
D. In a properly functioning network with redundant switched paths,each switched aegment will contain one root bridge with all its ports in the forwarding state.All other switches in that broadcast domain will have only one root port.
E. Establishing vlans increases the number of broadcast domains.
F. Switches that are configured with vlans make forwarding decisions based on both layer 2 and layer 3 address information.
A. show interfaces interface
B. show interfaces interface trunk
C. show interfaces interface switchport
D. show ip interface brief
E. show interfaces vlan
A. Router(config)#router ospf 1
B. Router(config)#router ospf 0
C. Router(config)#router ospf area 0
D. Router(config-router)#network 192.168.16.0 0.0.0.255 area 0
E. Router(config-router)#network 192.168.16.0 0.0.0.255 0
F. Router(config-router)#network 192.168.16.0 255.255.255.0 area 0
A. RIP requires less time to converge
B. RIP uses less bandwidth
C. RIP is less complex to configure
D. RIP demands fewer router resources
E. RIP has a more accurate metric
A. one IP network or subnetwork for each subinterface
B. subinterface numbering that matches vlan tages
C. subinterface encapsulation identifiers that match vlan tags
D. a management domain for each subinterface
E. one physical interface for each subinterface
F. one subinterface per vlan
A. A CSU/DSU terminates a digital local loop
B. A modem terminates a digital local loop
C. A CSU/DSU terminates an analog local loop
D. A modem terminates an analog local loop
E. A router is commonly considered a DTE device
F. A router is commonly considered a DCE device
最新试题
While troubleshooting a network problem,a technician discovers that the current copy of the Cisco IOS is outdated and needs to be updated.Which of the following commands would the technician issue to replace the Cisco router IOS with the newer version?()
Which device might be installed at a branch office to enable and manage an IPsec site-to-site VPN?()
What is the default administrative distance of OSPF?()
Which protocol reduces administrative overhead in a switched network by allowing the configuration of a new VLAN to be distributed to all the switches in a domain?()
How are VTP advertisements delivered to switches across the network?()
A network administrator needs to configure a serial link between the main office and a remote location.The router at the remote office is a non-cisco router. How should the network administrator configure the serial interface of the main office router to make the connection?()
At which layer of the OSI model dose PPP perform?()
What is the result of issuing the frame-relay map ip 192.168.1.2 202 broadcast command?()
A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?()Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0
A router receives information about network 192.168.10.0/24 from multiple sources.What will the router consider the most reliable information about the path to that network?()