In a deployment using standalone access points, clients set up to authenticate with eap-peap or eap-cisco wireless (cisco-leap) cannot authenticatE. when you inspect the failed attempts report on the cisco secure acs, you find this error: "unknown network access server nas."
Which problem may have caused this failure?()
A.misconfigured ip address of the aaa server on the access point
B.misconfigured eap type on the access point
C.misconfigured ip address of the access point on the aaa server
D.misconfigured eap type on the aaa server
您可能感兴趣的试卷
你可能感兴趣的试题
A.router (config-ssid)# guest-mode
B.router (config-ssid)# advertise
C.router (config-ssid)# enable
D.router (config-ssid)# broadcast
Yours truly,customer has deployed a cisco wireless location appliance within its warehouse
environment. however, employees there have been experiencing problems when tracking objects using active rfid tags. the rfid tag data is not being collected.
On which device would you verify that rfids have been enabled?()
A.access point
B.location manager
C.wireless controller
D.cisco wcs
A.partners having a discussion with customers about the minimum service components needed to successfully deploy a wireless solution
B.customers determining a competitor’s strategy for adopting advanced technologies
C.partners choosing the right products for their customers
D.customers choosing the right products for their network
E.customers defining the correct strategy for advanced technology adoption
A.five
B.three
C.six
D.four
A.cisco-leap,eap-fast,eap-peap(gtc),eap-tls
B.cisco-leap,eap-psk,eap-peap(ms-chap v2),eap-tls
C.cisco-leap,eap-fast,eap-peap(ms-chap v2),eap-ttls
D.cisco-leap,eap-md5,eap-peap(gtc),eap-ttls
You are using standalone cisco aironet 1400 series wireless bridges for a nine-mile point-to-point wireless link between two buildings.
Which distance setting should you use for the bridge configured as the root?()
A.20 km [12.4 miles]
B.10 km [6.2 miles]
C.5 km [3.1 miles]
D.25 km [15.5 miles]
E.15 km [9.3 miles]
When configuring a cisco 3845 integrated services router to support 802.11b and g clients.
Which of the following commands would be correct?()
A.router(config-if)# speed basic-1.0 2.0 5.5 6.0 9.0 11.0 12.0 18.0 24.0 36.0 48.0 54.0
B.router(config-if)# speed 1.0 2.0 5.5 6.0 9.0 basic-11.0 12.0 basic-18.0 24.0 36.0 48.0 54.0
C.router(config-if)# speed basic-1.0 2.0 5.5 basic-6.0 9.0 11.0 12.0 18.0 24.0 36.0 48.0 54.0
D.router(config-if)# speed 1.0 2.0 5.5 basic-6.0 9.0 11.0 12.0 18.0 24.0 36.0 48.0 54.0
A.enable concatenation on the non-root bridge only
B.enable concatenation on the root bridge only
C.enable concatenation on both the root bridge and non-root bridge
D.enable concatenation on the root bridge and set it as desirable on the non-root bridge
E.set concatenation as desirable on the root bridge and enable it on the non-root bridge
Eap-fast provides a secure tunnel during phase one to protect the user’s authentication credentials.
Which of these entities initializes the secure tunnel?()
A.x.509 certificate
B.generic token card
C.pre shared key
D.protected access credential
Your customer has deployed a cisco wireless location appliance within its warehouse
environment. however,employees there have been experiencing problems when tracking objects using active rfid tags. the rfid beacon rate is 10 seconds and you have discovered an issue with the rfid timeout value.
Where and how should the rfid value be changed?()
A.on the cisco wcs, to 95 seconds
B.on the wireless controller, to 45 seconds
C.on the wireless controller, to 95 seconds
D.on the cisco wcs, to 45 seconds
最新试题
Which of the following parameter sets must be configured on the Cisco Wireless Location Appliance?()
You have just finished aligning a Cisco Aironet 1400 Series Wireless Bridge link using installationmode. When you set the link back to operational mode you loose association to the root bridge.Which action will correct the problem?()
Clients using Cisco-LEAP and EAP-FAST authentication are having no problems logging on to thewireless network, but clients using PEAP are failing to log on.Which situation would result in thistype of problem?()
When configuring a WLAN controller for a voice application using Cisco 7920 wireless IP phones,which two general control settings should you select?()
When configuring Cisco Secure ACS to support wireless EAP authentication, which device must be configured as a AAA client?()
You are charges with implementing a secure wireless installation which will provide Internet accessto client devices but will not allow communications between wireless clients.In addition to implementing PSPF or peer-to-peer blocking on the wireless side,which of the following actionsshould you perform on the wired infrastructure?()
Static WEP is configured on the access point. You are authenticated and associated to the accesspoint but are unable to obtain an IP address.Which of the following will cause this problem?()
The IOS of a North American Cisco Aironet 1130AG Series standalone access point has becomecorrupt. You must therefore reload the TFTP firmware.Before you press and hold the MODEbutton, you should verify that the file name is which of the following?()
A Cisco Wireless Location Appliance has been added to track RFID tags placed on laptops beingused in a school.Classrooms at the school have concrete block walls. During testing,you discoverthat the accuracy of the system needs to be improved.You decide to edit the map in the Cisco WCS to add the interior walls.How many interior walls can you add to improve the accuracy of thelocation appliance?()
On a Cisco Aironet 802.11 a/b/g wireless LAN client adapter,the status LED and activity LED are alternating on and off.What does this indicate?()