A.Too much refrigerant
B.Too little refrigerant
C.Refrigerant is ran out
D.Running is over
您可能感兴趣的试卷
你可能感兴趣的试题
A.increase
B.reduce
C.maintain constant
D.None of the above is true
Which of the following may cause that excessively warm water leaves the condenser in a refrigeration plant? （）
(1) too little cooling water
(2) too much cooling water
(3) too warm cooler water
A.（1）only
B.anyof（1），（2）and（3）
C.anyof（1）and（3）
D.anyof（1）and（2）
Which of the following may cause that the compressor cuts off on high pressure cutout in a refrigeration plant? （）
(1) faulty condensing
(2) too few refrigerant
(3) high discharge pressure
A.any of (1) and (3)
B.any of (1) and (2)
C.any of (2) and (3)
D.any of (1), (2) and (3)
A.cutout
B.controller switch
C.pressure controller
D.cutout switch
A.evaporator
B.compressor
C.condenser
D.none of the above
A.nonexistent
B.for controlling pressure
C.for controlling superheat
D.for controlling the solenoid valve
A.compressor
B.condenser
C.throttle valve
D.evaporator
A.open-type
B.hermetic
C.semi-hermetic
D.all the above
Which of the following will be desirable properties of refrigerant?（）
(1) non-explosive
(2) non-corrosive
(3) that it doesn’t react with lubricants
A.(1), (2) and (3)
B.(1) and (2)
C.(1) and (3)
D.(2) and (3)
A.saturated
B.super-cooled
C.wet
D.superheated
最新试题
When the steering gear is in operation, you should （）.
The usual symptoms of cavitation in a centrifugal pump is （）.
If the relief valve on the discharge side of a hydraulic pump lifts, the cause could be （）.
If you are given the job of adding hydraulic fluid to a mooring winch, and are not certain as to the type of fluid to use, you should （）.
An increasing head pressure in a refrigeration system, without any corresponding change in the cooling water inlet temperature, would probably be caused by （）.
If the viscosity of the liquid being transferred remains constant as the discharge pressure increases, the rotary pump （）.
A salinity indicator is used to determine the （）.
A pressure drop through the refrigerant liquid line may cause （）.
The rate of heat transfer from a hot region to a cold region is affected most by the （）.
The general purpose of a heat exchanger is to （）.