A.pump would be very noisy
B.pump would vibrate excessively
C.pump would develop insufficient flow
D.stuffing box would leak excessively
您可能感兴趣的试卷
你可能感兴趣的试题
A.gravity and feed oil cups
B.grease cups
C.hand during installation
D.leakage through the stuffing box
A.a needle gun
B.soap and water
C.a wire brush
D.a chipping hammer
A.Hydrochloric acid
B.Chlorine
C.Sulfuric acid
D.Zinc chromate
A.absolute humidity
B.relative humidity
C.specific humidity
D.total humidity
A.excessive pump speed
B.excessive suction head
C.worn wearing rings
D.gross pump misalignment
A.Distillation is the process of boiling seawater to produce vapor which is condensed into fresh water
B.Evaporation is the second part of the distillation process where brine is removed
C.Brine is the result of condensed sea water vapor
D.Distillate is the product resulting from the evaporation of fresh water vapor
A.absolute humidity
B.specific humidity
C.effective humidity
D.relative humidity
A.drain water from the air receiver
B.drain water from the cylinders
C.delay the compression process until the motor is up to speed
D.check pump alignment
A.face shield
B.a respirator
C.rubber gloves
D.an all purpose gas mask
A.lantern rings
B.bearings
C.easing volutes
D.wearing rings
最新试题
If the thermal bulb of an expansion valve is incorrectly placed at the center of the coil instead of the end, it will （）.
A gradual decrease in the discharge pressure of an operating hydraulic pump can be caused by （）.
The rate of heat transfer from a hot region to a cold region is affected most by the （）.
A salinity indicator is used to determine the （）.
Which of the following problems could cause the high pressure cutout switch to shut down the compressor in a refrigeration system?（）
The rate of heat transfer between the hot and cold fluids passing through a shell-and-tube type heat exchanger will （）.
Which of the problems listed would came the discharge temperature of an R-12 refrigeration compressor to increase?（）
If the relief valve on the discharge side of a hydraulic pump lifts, the cause could be （）.
On tank vessels equipped with power operated cargo tank valves, the type of power operator most commonly used is （）.
If you are given the job of adding hydraulic fluid to a mooring winch, and are not certain as to the type of fluid to use, you should （）.