A.0mW
B.1mW
C.10mW
D.1.5mW
您可能感兴趣的试卷
你可能感兴趣的试题
A. amplifier
B. attenuator
C. regenerator
D. light emitter
E. optical switch
F. optical receiver
G. fiber-optic cable
A. fiber loss
B. OSNR level
C. post amplification
D. index of reflection
E. index of refraction
F. power post amplification budget
A. low optical power
B. high optical power
C. few optical channels
D. many optical channels
E. low chromatic dispersion
F. high chromatic dispersion
G. too much power differential in the optical channels
A. They are both regions of lowest loss.
B. They are both regions of low reflections.
C. They are both regions of low index of refraction.
D. They are both regions of low chromatic dispersion.
E. They are both regions of low Polarization Mode Dispersion (PMD).
A. lower cost
B. higher chirp
C. easier to manufacture
D. higher dispersion tolerance
E. higher optical signal-to-noise ratio
A. OSNR
B. dispersion
C. attenuation
D. power budget
E. amplifier spacing
F. four wave mixing
A. PIN photodiodes
B. zero-chirped lasers
C. Erbium-doped fiber amplifiers
D. dispersion compensating fiber
E. dispersion compensating Bragg grating
A.OSNR
B.dispersion
C.light skew
D.attenuation
A.none
B.one
C.two
D.three
E.four
Click the Exhibit button. What is the maximum allowable loss budget between the ONS 15216 Mux (left side) composite output and the ONS 15216 Demux (right side) composite input, with the optical values given in the exhibit? （）(Assume the worst case loss of 4.5 dB for 15216 200 GHz Mux/Demux and ignore power penalties or extra margin.)
A.15dB
B.17dB
C.21dB
D.26dB
E.27dB
最新试题
A 2.5 Gb/s (OC-48 or STM-16) optical signal with a dispersion tolerance of 1200 ps/nm goes through fiber with 18ps/nm*km of dispersion. How many 15216-DCU-350 equivalents are needed for enough compensation after traveling 100 km?（）
If the power is 0 dBm, what is the power in mW?（）
Click the Exhibit button. Which type of multiplexer is shown in the exhibit?（）
If node 2 is accepting line timing from node 1, node 2 will send （）to node 1 as its SSM message.
What are three relevant design considerations when using the 15216 EDFA? （）(Choose three.)
SONET Code Violations (CVs) totals in the PM tables are actually an accumulation of the number of （）.
Click the Exhibit button. Given the following parameters: transmitter output (min): -2 dBm receiver input (min): -28 dBm 15216 Mux and Demux loss: 4.5 dB 16 channels maximum In which sites shown in the exhibit could the 15216 EDFAs be placed to minimize the number of EDFAs needed?（）
The ONS 15216 is a 32-channel system. The ONS 15216 OADMs are capable of adding and dropping one, two, or four channels. How are the OADMs provisioned to add and drop specific channels?（）
Click the Exhibit button. When designing a DWDM system with multiple amplified spans, a pre-amp is needed at Site B to （）. (Choose three.)
What are two important considerations when using 2- or 4-channel 15216 OADMs?（） (Choose two.)