A.255.255.255.0
B.255.255.255.192
C.255.255.255.250
D.255.255.255.252
您可能感兴趣的试卷
你可能感兴趣的试题
A.On router R2, configure a default static route to the 192.168.1.0 network.
B.On router R2, configure DNS to resolve the URL assigned to Web Server 2 to the 192.168.1.10 address.
C.On router R1, configure NAT to translate an address on the 209.165.100.0/24 network to 192.168.1.10.
D.On router R1, configure DHCP to assign a registered IP address on the 209.165.100.0/24 network to Web Server 2.
A.0
B.1
C.2
D.3
E.4
A.ip route 0.0.0.0 0.0.0.0 s0/0/0
B.ip route 0.0.0.0 0.0.0.0 209.165.200.226
C.ip route 209.165.200.0 255.255.255.0 192.168.1.250
D.ip route 192.168.1.0 255.255.255.0 209.165.100.250
A.using adapters and access points manufactured by the same company
B.overlapping the wireless cell coverage by at least 10%
C.configuring all access points to use the same channel
D.utilizing MAC address filtering to allow the client MAC address to authenticate with the surrounding APs
A.AES-CCMP
B.PPK via IV
C.PSK
D.TKIP/MIC
A.transparent
B.auto
C.on
D.desirable
E.blocking
F.forwarding
A.Full-duplex Ethernet consists of a shared cable segment. Half-duplex Ethernet provides a point-to-point link.
B.Full-duplex Ethernet uses a loopback circuit to detect collisions. Half-duplex Ethernet uses a jam signal.
C.Full-duplex Ethernet can provide higher throughput than can half-duplex Ethernet of the same bandwidth.
D.Full-duplex Ethernet uses two wires to send and receive. Half-duplex Ethernet uses one wire to send and receive.
A.copier
B.microwave oven
C.toaster
D.cordless phone
E.IP phone
F.AM radio
A.VTP
B.STP
C.ISL
D.802.1Q
E.VLSM
A.buffering
B.cut-through
C.windowing
D.congestion avoidance
E.load balancing
最新试题
When you are troubleshooting an ACL issue on a router,which command can help you to verify which interfaces are affected by the ACL?()
Which cisco ios command can help to determine the timing of various debug events,relative to each other,when you are debugging a complicated router issue?()
Which pairing reflects a correct protocol-and-metric relationship?()
An employee of ABC company has move to an office on a different floor. Although the administrator is able to telnet to all of the routers,the address of Switch F is needed in order to verify that the employee remains in the same VLAN.Which action could be used by the administrator to find the IP address of Switch F?()
What is the subnetwork address for a host with the IP address 201.100.5.68/28?()
A network administrator is planning a network installation for a large organization.The design requires 100 separate subnetworks,so the company has acquired a Class B network address.What subnet mask will provide the 100 subnetworks required, if 500 usable host addresses are required per subnet?()
After the show ip route command has been entered,the follwing routes are displayed.Which route will not be entered into the routing table of a neighboring router?()
On which options are standard access list based?()
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?()
At which layer of the OSI model dose PPP perform?()