A. configure static frame relay map entries for each subinterface network.
B. remove the ip address from the physical interface
C. create the virtual interfaces with the interface command
D. configure each subinterface with its own IP address
E. disable split horizon to prevent routing loops between the subinterface networks
F. encapsulate the physical interface with multipoint PPP
您可能感兴趣的试卷
你可能感兴趣的试题
A.show inventory
B.show flash:filesys
C.dirflash:include chassis
D.show diag
E.show controllers
A. RIP is an example of distance vector routing protocols.
B. Updates are periodic and include the entire routing table.
C. Routing updates are sent only after topology changes
D. The protocol can be useful in hub-and-spoke and hierarchical networks.
E. Convergence is usually faster than with link state protocols
F. Each router has its own view of the topology
A.172.22.243.127
B.172.22.243.191
C.172.22.243.190
D.10.16.33.98
E.10.17.64.34
F.192.168.1.160
A. The network administrator can apply port security to dynamic access ports
B. The network administrator can configure static secure or sticky secure mac addresses in the voice vlan.
C. The sticky learning feature allows the addition of dynamically learned addresses to the running configuration.
D. The network administrator can apply port security to EtherChannels.
E. When dynamic mac address learning is enabled on an interface,the switch can learn new addresses,up to the maximum defined.
A. they offer simpler management in large internetworks.
B. you can control logging messages.
C. they allow packets to be filtered based on upper-layer session information.
D. you can set a time-based security policy.
E. they provide a level of security against spoofing.
F. they are used to authenticate individual users.
A. it is a layer 2 messaging protocol which maintains vlan configurations across network.
B. it includes an 8-bit field which specifies the priority of a frame.
C. it is used exclusively for tagging vlan frames and dose not address network reconvergence following switched network topology changes.
D. it modifies the 802.3 frame header,and thus requires that the FCS be recomputed.
E. it is a trunking protocol capable of carring untagged frames.
A.PPP
B.FDDI
C.Frame Relay PVC
D.NBMA
E.Frame Relay SVC
A. Microsegmentation decreases the number of collisions on the network.
B. if a switch receives a frame for an unkown destination,it uses ARP to resolve the address.
C. Spanning Tree Protocol allows switches to automatically share vlan information.
D. In a properly functioning network with redundant switched paths,each switched aegment will contain one root bridge with all its ports in the forwarding state.All other switches in that broadcast domain will have only one root port.
E. Establishing vlans increases the number of broadcast domains.
F. Switches that are configured with vlans make forwarding decisions based on both layer 2 and layer 3 address information.
A. show interfaces interface
B. show interfaces interface trunk
C. show interfaces interface switchport
D. show ip interface brief
E. show interfaces vlan
A. Router(config)#router ospf 1
B. Router(config)#router ospf 0
C. Router(config)#router ospf area 0
D. Router(config-router)#network 192.168.16.0 0.0.0.255 area 0
E. Router(config-router)#network 192.168.16.0 0.0.0.255 0
F. Router(config-router)#network 192.168.16.0 255.255.255.0 area 0
最新试题
While troubleshooting a network problem,a technician discovers that the current copy of the Cisco IOS is outdated and needs to be updated.Which of the following commands would the technician issue to replace the Cisco router IOS with the newer version?()
A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?()Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0
What is the subnetwork address for a host with the IP address 201.100.5.68/28?()
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?()
Which command is used to display the collection of OSPF link states?()
Which cisco ios command can help to determine the timing of various debug events,relative to each other,when you are debugging a complicated router issue?()
What is the purpose of the cisco Vlan Trunking protocol?()
Which statement describes the rule of split horizon?()
A network administrator needs to configure a serial link between the main office and a remote location.The router at the remote office is a non-cisco router. How should the network administrator configure the serial interface of the main office router to make the connection?()
Which protocol reduces administrative overhead in a switched network by allowing the configuration of a new VLAN to be distributed to all the switches in a domain?()