A.IPv6 multicast uses Multicast Listener Discovery.
B.The first 8 bits of an IPv6 multicast address are always FF （1111 1111）.
C.IPv6 multicast requires MSDP.
D.PIM dense mode is not part of IPv6 multicast.
您可能感兴趣的试卷
你可能感兴趣的试题
A.Sent by the destination
B.Received by the sender
C.Received by the destination
D.Sent by the sender
A.Only UplinkFast and BackboneFast are specified in 802.1w； PortFast must be manually configured.
B.Only PortFast is specified in 802.1w； UplinkFast and BackboneFast must be manually configured.
C.None of the proprietary Cisco enhancements are specified in 802.1w.
D.PortFast， UplinkFast， and BackboneFast are specified in 802.1w.
A.Speed mismatch
B.Incorrect encapsulation
C.MTU set too low
D.Duplex mismatch
A.EBGP multihop will need to be configured for this to work.
B.This should work with normal BGP peering， with no additional configuration on the BGP speakers or the firewall.
C.The BGP protocol port must be opened on the firewall
D.There is no way to make BGP work across a firewall.
A.The stack bit will only be used when LDP is the label distribution protocol
B.The label is the last entry in the label stack.
C.The stack bit is for Cisco implementations exclusively and will only be used when TDP is the label distribution protocol.
D.The stack bit is reserved for future use.
A.Reverse Path Forwarding
B.Hardware-based forwarding
C.UDP forwarding
D.Layer 2 Forwarding
A.The firewall does not support Cisco Discovery Protocol. You should set the switchport trunk mode ON
B.The firewall does not support Cisco Discovery Protocol. You should set the switchport trunk mode to OFF
C.The firewall does not support Cisco Discovery Protocol. You should set the switchport trunk mode asauto.
D.The firewall does not support DTP. You should set the switchport trunk mode to ON
A.0.0.0.1
B.0.255.0.1
C.2001：DB8：：1
D.2001：DB8：ABCD：FEEF：：1
A.excessive collisions
B.FCS errors
C.runts
D.late collisions
A.BPDUs that enter a blocking port are discarded.
B.BPDUs that enter a blocking port are processed.
C.Loopguard puts an interface into a loop-inconsistent state when BPDUs stop being received on a blocking port.
D.BPDUs are only processed on forwarding ports.
最新试题
Policy-based routing allows network administrators to implement routing policies to allow or deny paths based on all of these factors except which one？（）
An administrator of a peer-to-peer server application reports that the maximum bandwidth that his application receives is 90 Mb/s. You have an 8-port，100-Mb/s EtherChannel bundle on the switching infrastructure between the two servers， resulting in a bidirectional throughput of more than what is recorded. Which two solutions would allow for more bandwidth for the application？（）
You are the network administrator of an enterprise company that just deployed a global IP telephony environment. In order to guarantee good voice quality， you asked your provider to implement QoS on the CE routers of your MPLS network. On your LAN， you have also deployed QoS. Users， however， keep complaining about bad voice quality， and the provider does not see matches on the DSCP values that you have asked him to match upon. What is most likely the problem？（）
Two directly connected routers， R1 and R2， are both configured for OSPF graceful restart. R2 is able to switch packets in hardware， but R1 is not. If a network administrator logs on to R2 and performs a system reload， which will be the result？（）
What does a unicast prefix-based IPv6 multicast address start with？（）
For the following ports， which port is on every bridge in a Spanning Tree Protocol IEEE 802.1w network except the root bridge？（）
Which one of the following potential issues is eliminated by using split horizon？（）
Which three protocols should be explicitly managed by using Control Plane Policing on an Internet border router？（）
Phase I and Phase II DMVPN differ in terms of which of these characteristics？（）
f a Cisco switch is configured with VTPv1 in transparent mode， what is done with received VTP advertisements？（）