A.lower than
B.higher than
C.below
D.equal to
您可能感兴趣的试卷
你可能感兴趣的试题
A.fire-tubes
B.furnaces
C.down-comers
D.soot-blowers
A.The domestic water
B.Bilge water
C.Oil transfer
D.The ballast
A.A cut-off lever
B.A swivel block
C.A cross-head
D.A driving gear
A.the piston rod
B.the tiller arm
C.the connecting rod
D.the rudder
A.fouled tubes in shell and tube condenser
B.too little or too warm condenser water
C.air or non-condensable gas in system
D.overcharge of refrigerant
A.The winch motor
B.The band brake
C.The winch barrel
D.The anchor capstan
A.The cable lifter
B.The hoisting motor
C.The topping wire
D.The life-raft
A.stays
B.winches
C.barrels
D.brakes
A.fire-tubes
B.furnaces
C.water drums
D.water wall tubes
A.The three moving vanes and the three fixed vanes form three pressure chambers
B.The three moving vanes and the three fixed vanes form six pressure chambers
C.The three moving vanes and the three fixed vanes form nine pressure chambers
D.The three moving vanes and the three fixed vanes form twelve pressure chambers
最新试题
The rate of heat transfer between the hot and cold fluids passing through a shell-and-tube type heat exchanger will ().
A grease gun is generally used to lubricate a ().
The temperature differential occurring between the inlet temperature of the fluid to be cooled and the outlet temperature of the cooling medium in a shell-and-tube heat exchanger is greatest in which of the flow designs listed?()
The output volume of a positive fixed displacement pump can be changed only by ().
If the relief valve on the discharge side of a hydraulic pump lifts, the cause could be ().
An increasing head pressure in a refrigeration system, without any corresponding change in the cooling water inlet temperature, would probably be caused by ().
If the viscosity of the liquid being transferred remains constant as the discharge pressure increases, the rotary pump ().
The amount of fluid friction or internal friction inherent in a mineral lubricating oil is reflected as a measure of its ().
Which of the following statements is correct concerning heat transfer?()
A salinity indicator is used to determine the ().