A.A request made by a node for the IP address of the local router
B.A request made by a node to join a specified multicast group
C.A request made by a node for a DHCP provided IP address
D.A request made by a node for the IP address of the DHCP server
您可能感兴趣的试卷
你可能感兴趣的试题
A.2031：0：130F：0：0：09C0：876A：130B
B.2031：：130F：：9C0：876A：130B
C.2031：0：130F：：9C0：876A：130B
D.2031：0：130F：0：0：9C0：876A：130B
A.Traffic forwarded from R2 to or through R1 will continue to be forwarded based on the forwarding table state at the time of the reload.
B.R2 will continue to forward traffic to R1， but R1 will drop the traffic because its neighbor adjacency with R2 has failed.
C.R2 will continue forwarding traffic to and through R1， but R1 will drop this traffic because it is not capable of maintaining its forwarding state.
D.All the traffic R2 is forwarding to or through R1 will be dropped while OSPF rebuilds its neighbor adjacency and forwarding tables.
A.It ensures that BPDUs sent by the root bridge are forwarded in a timely manner
B.It enforces the root bridge placement in the network
C.It ensures that all ports receiving BPDUs from the root bridge are in the forwarding state.
D.It ensures that the bridge is elected as root bridge in the network.
A.IPv6 multicast uses Multicast Listener Discovery.
B.The first 8 bits of an IPv6 multicast address are always FF （1111 1111）.
C.IPv6 multicast requires MSDP.
D.PIM dense mode is not part of IPv6 multicast.
A.Sent by the destination
B.Received by the sender
C.Received by the destination
D.Sent by the sender
A.Only UplinkFast and BackboneFast are specified in 802.1w； PortFast must be manually configured.
B.Only PortFast is specified in 802.1w； UplinkFast and BackboneFast must be manually configured.
C.None of the proprietary Cisco enhancements are specified in 802.1w.
D.PortFast， UplinkFast， and BackboneFast are specified in 802.1w.
A.Speed mismatch
B.Incorrect encapsulation
C.MTU set too low
D.Duplex mismatch
A.EBGP multihop will need to be configured for this to work.
B.This should work with normal BGP peering， with no additional configuration on the BGP speakers or the firewall.
C.The BGP protocol port must be opened on the firewall
D.There is no way to make BGP work across a firewall.
A.The stack bit will only be used when LDP is the label distribution protocol
B.The label is the last entry in the label stack.
C.The stack bit is for Cisco implementations exclusively and will only be used when TDP is the label distribution protocol.
D.The stack bit is reserved for future use.
A.Reverse Path Forwarding
B.Hardware-based forwarding
C.UDP forwarding
D.Layer 2 Forwarding
最新试题
When two bridges are competing for the root bridge of an IEEE 802.1D spanning tree and both have the same bridge priority configured， which parameter determines the winner？（）
In which way can the IPv6 address of 2031：0000：130F：0000：0000：09C0：876A：130B be expressed most efficiently？（）
What are the "bound IP addresses" used for in LDP？（）
Which three are needed to run VRF lite for IPv6 on a router？ （）
An administrator of a peer-to-peer server application reports that the maximum bandwidth that his application receives is 90 Mb/s. You have an 8-port，100-Mb/s EtherChannel bundle on the switching infrastructure between the two servers， resulting in a bidirectional throughput of more than what is recorded. Which two solutions would allow for more bandwidth for the application？（）
In GLBP， which router will answer on client ARP requests？（）
Internet Protocol version 6 （IPv6） is the next-generation Internet Layer protocol for packet-switched internetworks and the Internet. IPv6 router solicitation is（）
f a Cisco switch is configured with VTPv1 in transparent mode， what is done with received VTP advertisements？（）
You are the network administrator of a Layer 3 switched network. Users in one VLAN are complaining that access to the server VLAN is very slow from time to time. Traffic in the local VLAN works without any issue， and users in other VLANs do not have any complaint to reach the server VLAN. What is most likely the cause of this issue？（）
When a BGP router is not capable of understanding 4-byte AS numbers， it will see 4-byte AS numbers as a special， reserved， 2-byte AS number in the AS path. Which 2-byte AS number is this reserved one？（）